Proces Liquid Filtration » Filter Bags
Filter Bags
Standard filter bags data sheet
XLH Filter bags data sheet
Bag filters are used typically for high flow rate applications
where quick and simple filter bag changeout is required.
Bag filters are unable to offer the same level of efficiency and degree of fineness
that can be achieved using a cartridge filtration system. However when it comes
to volume throughput and cost of operation then very little can beat a bag filter
installation.
We offer a range of bag filter housings that are designed to accept the main
industrial range of bag filter sealing mechanisms, whether it be the simple wire
neck ring or the more complex and more efficient moulded style of neck ring,
we will have a vessel to suit.
At the smaller end of the vessel range we have units available in
either stainless steel or moulded polypropylene. These have connection
options normally up to 1 ½" BSP thread and will accommodate
flow rates (viscosity =1cP) up to 5 cu.m/hour.
In the intermediate range we have industry standard single, double
and triple length vessels which will accept either standard 7" diameter
steel wire neck rings or moulded neck seal design. These vessels
will accommodate flow rates up to 50 cu.m/hour, the single and double
length units are available in 316L stainless steel or glass fibre
reinforced polypropylene. The larger triple length unit is available
in 316L stainless steel only.
For higher flow rate capabilities we offer vessels that contain a multiple number
of filter bags ( multi pods) with up to 12 double length bag units available
as standard designs, and even larger units able to be manufactured to special
design.
Whilst not all designs are required to be manufactured to gain CE marking to
comply with PED, there are options within the range that will be CE marked signifying
their suitability for use with all Group 2 Fluids and gases and all Group 1 fluids
except those classified as oxidising or explosive.
Mini bags are based on a 4.25" diameter neck ring and are suitable
for applications where if the flow rate is less than 5 cu. li/hr.
These filter bags are available in all standard felts and a range
of nylon microfilaments up to 1000 microns.
We offer a range of filter housings to suit
these bags in either polypropylene or stainless steel (316l), and connections
of up to 2".
To complement the vessel range we offer a range of filter bags that give nominal
filtration ratings in the range 0.5 microns up to 1mm (see bag data for specific
materials and micron ratings.
| 81 Series Mini Bag Housing | 84 Series Single Bag Housing | ||
|
|
 |
data
sheet |
| 85 Series Single Bag Housing | 86 Series Single Bag Housing | ||
 |
data
sheet |
 |
data
sheet |
